Roller Brake Tester – Motorcycles

Roller brake tester suitable for diagnostic brake measurement and periodic technical inspection of 2 wheeled motorcycles, mopeds and scooters. It is mounted with special wheel slip sensors and load cells to measure brake force. The equipment and the measurements are controlled by Energoline® test lane software. During brake measurements the motorcycle is fixed by built-in vices, therefore continuous handle-bar holding with two hands is ensured.

• Brake measurement of L1e, L3e vehicle categories
• Can be installed above floor or under floor
• Measuring electronics based on CAN system
• Pneumatic wheel fixing unit for the front and the rear wheel
• Measurements controlled by foot-actuated switches
• Brake measurement versus time, pedal force or hand-brake actuating force

Requirements for installation:

• Preparation of concrete bed / groundwork
• Preparation of tracks for electronic cables
• Preparation of electrical installation (main supply)
• Preparation of compressed air terminal with oiling system, pressure regulator and protective tubing for pneumatic tube