Roller Brake Testers – Cars & Light Commercial Vehicles – 3.5t – Elongated Rollers

The roller brake tester is equipped with elongated rollers. It is suitable for diagnostic brake measurement and for periodical technical inspection of vehicles with 3.5 t total weight. The divided mechanical unit can be sunk level with the ground. It is mounted with special wheel slip sensors and load cells to measure brake force. The equipment and the measurements are controlled by Energoline® test lane software. SZFE-Q is suitable to measure vehicles with narrower track width (quads) too and SZFE-T is suitable to measure vehicles with wider track width (trailers) too.

• SZFE-Q is suitable for brake measurements of L6e, L7e, M1, N1, O1, O2 vehicle categories
• SZFE-T is suitable for brake measurements of M1, N1, O1, O2 vehicle categories
• Elevated rear rollers to measure higher brake forces
• Measuring electronics based on CAN system
• Brake measurement versus time and pedal force
• Drive-out aid with fixed rollers
• 4WD measurement (option)

Requirements for installation:

• Preparation of concrete bed / groundwork with edge protection frame
• Preparation of electrical installation and protective tubing
• Preparation of tracks for electronic cables